Skip to main content
Alpha

This is a rebuild of Drinking Water Watch and not yet the official record. Use the agency’s current Drinking Water Watch for anything you need to rely on.

TTHM results

MS0430002 , City of Brookhaven

61 samples have been analysed for TTHM at City of Brookhaven.

This is one analyte out of the system’s whole record. For what has ever been detected here, and when, see all chemical and radiological results; for everything the system is tested for, see the analyte list.

What counts as a non-detect is defined in the help: Less than Indicator. This system’s violations.

No date range is applied: this list draws on every sample on record. Show the last two years only.

Every TTHM result

The table below lists 31–40 of 61 samples, newest first — collected November 2, 2009 to October 23, 2013.

10 TTHM results from the 10 samples listed here: 8 detected, 2 not detected. Those samples also carried 40 results for other analytes, which are on the full results page.

Units in this table

TTHM is recorded on this page in ug/l and mg/l. 1 mg/l = 1,000 ug/l.

We withheld the location of 2 sampling points below. The location on record identifies a private home, and we do not publish those. That is our decision, not the agency’s. The sampling point, its type and every result taken there are published unchanged.

TTHM results for City of Brookhaven, from 31 to 40 of 61 samples shown analysed for it, newest first. This view leaves out other analytes on the same samples. Not detected means the amount was below the level the laboratory can reliably report, which is given beside it.
Result Analyte Monitoring period
Collected
Oct 23, 2013 02:05
Sampling point
SM1 Location withheld
Sample type
Routine
Lab sample
131024-006TH
Laboratory
MSDH Lab
3.35 ug/l , sample collected Oct 23, 2013 02:05, sampling point SM1 TTHM 2950 EPA method 524.2 Not recorded
Collected
Oct 23, 2013 01:05
Sampling point
SM2 Location withheld
Sample type
Routine
Lab sample
131024-005TH
Laboratory
MSDH Lab
Not detected below 4 ug/l Minimum Reporting Level , sample collected Oct 23, 2013 01:05, sampling point SM2 TTHM 2950 EPA method 524.2 Not recorded
Collected
Jun 10, 2013 01:05
Sampling point
MRT000 Max. Res. Time
Sample type
Routine
Lab sample
130611-008TH
Laboratory
MSDH Lab
18.1 ug/l , sample collected Jun 10, 2013 01:05, sampling point MRT000 TTHM 2950 EPA method 524.2 Jan 1, 2013 – Dec 31, 2013
Collected
Jun 11, 2012 01:05
Sampling point
MRT000 Max. Res. Time
Sample type
Routine
Lab sample
120612-007TH
Laboratory
MSDH Lab
16.91 ug/l , sample collected Jun 11, 2012 01:05, sampling point MRT000 TTHM 2950 EPA method 524.2 Jan 1, 2012 – Dec 31, 2012
Collected
Jul 25, 2011 01:10
Sampling point
MRT000 Max. Res. Time
Sample type
Routine
Lab sample
110726-013TH
Laboratory
MSDH Lab
22.92 ug/l , sample collected Jul 25, 2011 01:10, sampling point MRT000 TTHM 2950 EPA method 524.2 Jan 1, 2011 – Dec 31, 2011
Collected
Aug 9, 2010
Sampling point
MRT000 Max. Res. Time
Sample type
Routine
Lab sample
100810-006TH
Laboratory
MSDH Lab
18.48 ug/l , sample collected Aug 9, 2010, sampling point MRT000 TTHM 2950 EPA method 524.2 Jan 1, 2010 – Dec 31, 2010
Collected
Feb 1, 2010
Sampling point
SM2 Location withheld
Sample type
Routine
Lab sample
100202-032TH
Laboratory
MSDH Lab
1.3 ug/l , sample collected Feb 1, 2010, sampling point SM2 TTHM 2950 EPA method 524.2 Not recorded
Collected
Feb 1, 2010
Sampling point
SM1 Location withheld
Sample type
Routine
Lab sample
100202-031TH
Laboratory
MSDH Lab
0 This result is recorded as a detection, and the figure the agency wrote — "0.00" — is zero to the precision it was written to. Read the zero as "smaller than the written figure resolves", not as "none present". SDWIS holds a separate numeric concentration that Drinking Water Watch does not publish, so this endpoint does not carry it either; no more precise magnitude is available here. The agency recorded a value but no unit of measure for it. The unit is NOT inferable from the analyte: many analytes are reported in more than one unit — TTHM and HAA5 in both MG/L and UG/L — so there is no per-analyte default to fall back on. The number is published as it stands and must not be compared to a limit. The agency recorded which kind of limit this result was below, but stored 0.000000000 as the limit itself, which is not a level. The type is published and the value is null. What the limit was is not on record. Whether the result was a detection is a separate column: read resultType. , sample collected Feb 1, 2010, sampling point SM1 TTHM 2950 EPA method 524.2 Not recorded
Collected
Nov 2, 2009
Sampling point
SM2 Location withheld
Sample type
Routine
Lab sample
091103-010TH
Laboratory
MSDH Lab
Not detected below 4 ug/l Minimum Reporting Level , sample collected Nov 2, 2009, sampling point SM2 TTHM 2950 EPA method 524.2 Not recorded
Collected
Nov 2, 2009
Sampling point
SM1 Location withheld
Sample type
Routine
Lab sample
091103-009TH
Laboratory
MSDH Lab
6.34 ug/l , sample collected Nov 2, 2009, sampling point SM1 TTHM 2950 EPA method 524.2 Not recorded

Routine (10).